What This Plate Offers Your Build
The eitech Plate 11x5-hole, angled on both sides is a component from the eitech Manufaktur line, designed for adding angled sections to your metal construction models. With 11 holes along one axis and 5 along the other, and edges that are angled on both sides, this plate lets you create non‑right‑angle connections without bending or modifying other parts.
Whether you are building a crane boom, a vehicle chassis, or an architectural frame, this plate helps you change direction smoothly. It is available as SKU 01112 in the Standard variant.
Catalog Facts
- Plate 11x5-hole, angled on both sides: The eitech Plate 11x5-hole, angled on both sides is a component from the eitech Manufaktur line, offered under SKU 01112 in the Standard variant. Knowing the SKU helps you order the exact part for your project.

Plate 11x5-hole, angled on both sides - Plate 11x5-hole, angled on both sides: It is designed as a plate with 11 by 5 holes and angled edges on both sides. The 11x5 hole pattern gives you many connection points, while the angled edges allow you to create angled joints without extra brackets.
Where to Use the Angled Plate in Your Model
Because both long edges are angled, the plate can serve as a corner brace or a transition piece between two differently oriented frame sections. For example, you might bolt it between a horizontal beam and a vertical column to introduce a slight tilt, or use it as the side panel of a tapered structure like a crane jib.
The 11x5 hole grid gives you plenty of attachment points for screws and nuts, so you can secure it firmly to other plates or flat bars. Combine it with straight plates and angle girders to build complex three‑dimensional shapes.
What the Supplied Information Does Not Confirm
The supplied records do not specify the exact angle of the plate's edges, nor do they list recommended bolt sizes or torque values. For assembly, use standard eitech hardware and tighten connections by feel until the joint is snug. If your build requires precise alignment, test‑fit the plate with a few screws before final tightening.


